Nissan Maxima Service and Repair Manual: Removal and installation

Preparation

Special Service Tool The actual shapes of the tools may differ from those illustrated here. Commercial Service Tool Sealant and/or Lubricant ...

Control unit

Removal and Installation A/C SWITCH ASSEMBLY Removal Remove cluster lid D. Refer to IP-10, "Exploded View". Remove the A/C switch assembly from cluster lid D. Installation Instal ...

Other materials:

Combination meter
Reference Value VALUES ON THE DIAGNOSIS TOOL NOTE: * The monitor will indicate "OFF" even though the brake warning lamp is on if either of the following conditions exist: The parking brake is engaged The brake fluid level is low TERMINAL LAYOUT PHYSICAL VALUES Fail Safe ...

Condenser
Removal and Installation REMOVAL Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation". Disconnect the harness connector, remove bolt (A), and then remove condenser (1) from the vehicle body. INSTALLATION Installation is in the reverse order of ...

Navigation Swipe to Meter
Turn-by-turn route guidance can also be viewed in the vehicle information display by using Navigation Swipe to Meter. This can be done by programming a route, touching the turn-by-turn route icon on the center display, and swiping towards the general direction of the vehicle information di ...