Nissan Maxima Service and Repair Manual: Tilt &telescopic switch ground circuit

Power seat switch ground circuit

Diagnosis Procedure 1. CHECK POWER SEAT SWITCH LH GROUND CIRCUIT Turn ignition switch OFF. Disconnect power seat switch LH. Check continuity between power seat switch LH connector and ...

Front door switch (driver side)

Description Detects front door LH open/close condition. Component Function Check 1. CHECK FUNCTION Select "DOOR SW-FL" in "DATA MONITOR" mode with CONSULT. Check the front door switch signal ...

Other materials:

CVT fluid
Inspection CHECKING CVT FLUID The fluid level should be checked with the fluid warmed up to 50 to 80C (122 to 176F). The fluid level check procedure is as follows:  Check for fluid leakage.  With the engine warmed up, drive the vehicle in an urban area. When amb ...

Lifting sensor (rear)
Description The lifting sensor (rear) is installed to the seat frame. The pulse signal is input to the driver seat control unit when the lifting (rear) is operated. The driver seat control unit counts the pulse and calculates the lifting (rear) amount of the seat. Component Function ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...