Nissan Maxima Service and Repair Manual: U1010 control unit (CAN)

DTC Logic

DTC DETECTION LOGIC

Nissan Maxima. DTC DETECTION LOGIC

Diagnosis Procedure

1. REPLACE BCM

When DTC [U1010] is detected, replace BCM.

Special Repair Requirement

1. REQUIRED WORK WHEN REPLACING BCM

Initialize NVIS by CONSULT. For the details of initialization refer to CONSULT Immobilizer mode and follow the on-screen instructions

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excell ...

    B2622 inside key antenna 2
    Description Detects whether Intelligent Key is inside the vehicle. Installed under the center console. DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following ...

    Other materials:

    Combination switch reading system
    System Diagram System Description OUTLINE BCM reads the status of the combination switch (light, turn signal, wiper and washer) and recognizes the status of each switch. BCM has a combination of 5 output terminals (OUTPUT 1 - 5) and 5 input terminals (INPUT 1 - 5) and reads a maximum ...

    Radius rod
    Removal and Installation Removal Remove the rear wheel and tire using power tool. Refer to WT-60, "Adjustment". Remove the radius rod nut and bolt from the rear axle housing using power tools. Remove the radius rod bolt from the rear suspension member using power tools. Remove th ...

    Shift lock release
    If the battery charge is low or discharged, the shift lever may not be moved from the P (Park) position even with the brake pedal depressed and the shift lever button pressed. It will be necessary to jump start or have your battery charged, For additional information, refer to "Jump star ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0087