PrecautionDLC branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the data link connector for
damage, bend and loose connection
(connector side and harness side).
2.CHECK HARNESS FOR OP ...
Extending engine run time
The remote start feature can be extended one
time by performing the steps listed in "Remote
starting the vehicle" in this section. Run time will
be calculated as follows:
The first 10 minute run time will start when
the remote start function is performed.
The second 10 minutes will start ...
Installing front license plate
Use the following steps to mount the front license
plate:
1. Make holes on the plastic finisher at the
location mark (small dimple) using a 5 mm
(0.20 in) drill. Apply light pressure to the drill.
Install the license plate holder using the two
screws provided with the holder.
2. Mount ...