Nissan Maxima Service and Repair Manual: Wiring diagram

ECU diagnosis information

BCM (BODY CONTROL MODULE) Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional informat ...

Power door lock system

Wiring Diagram ...

Other materials:

Crash zone sensor
Component Crash zone sensor harness connector Crash zone sensor Nut Front Removal and Installation CAUTION: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes. Do not use air tools or electric tools for servicing. ...

P1777 step motor
Description The step motor changes the step by turning 4 coils ON/OFF according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive ve ...

Manual shift mode
The transmission enters the manual shift mode by moving the shift lever to the left side in the "D" range. You can select the manual shift range either by moving the shift lever up or down, or by pulling the right-side or left-side paddle shifter (if so equipped). To cancel the manual shift ...