Nissan Maxima Service and Repair Manual: Basic inspection

Preparation
PREPARATION Special Service Tools The actual shapes of the tools may differ from those illustrated here. Commercial Service Tools ...

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the inciden ...

Other materials:

P0448 evap canister vent control valve
Description The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid valve responds to signals from the ECM. When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal ...

ABS function does not operate
Diagnosis Procedure CAUTION: ABS does not operate when speed is 10 km/h (6 MPH) or lower. 1.CHECK ABS WARNING LAMP DISPLAY Make sure that the ABS warning lamp turns OFF after ignition switch is turned on or when driving 2.CHECK WHEEL SENSOR AND SENSOR ROTOR Check the following: Wheel se ...

P0715 input speed sensor A
Description The primary speed sensor detects the primary pulley revolution speed and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", a ...

Nissan Maxima Owners Manual

Nissan Maxima Service and Repair Manual

© 2017-2026 Copyright www.nimainfo.com
0.0119