Diagnosis Procedure
1. CHECK FRONT POWER WINDOW MOTOR RH CIRCUIT
Check front power window motor RH circuit
Driver side power window alone does not operate
Rear LH side power window alone does not operateKey slot
Removal and Installation
REMOVAL
Remove the instrument lower panel LH. Refer to
IP-19, "Removal and Installation".
Remove the switch assembly screws (A), remove
the key slot
screws (B) and then remove key slot (1) from instrument lower
panel LH (2).
IN ...
Removal and installation
BCM (BODY CONTROL MODULE)
Removal and Installation
For removal and installation of the BCM.
PUSH BUTTON IGNITION SWITCH
Removal and Installation
REMOVAL
Remove push-button ignition switch from cluster lid A using a
suitable tool.
Disconnect harness connector from push-button ignition s ...
Harness connector
Description
HARNESS CONNECTOR (TAB-LOCKING TYPE)
The tab-locking type connectors help prevent accidental looseness
or disconnection.
The tab-locking type connectors are disconnected by pushing or
lifting the locking tab(s). Refer to the figure
below.
Refer to the next page for desc ...