Nissan Maxima Service and Repair Manual: Preparation

Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a fro ...

Removal and installation

SUNROOF UNIT ASSEMBLY Inspection WIND DEFLECTOR Open glass lid assembly fully. Visually check for proper installation, damaged/deteriorated components, or foreign objects within mechanism ...

Other materials:

System maintenance
The sensor for the ICC system A is located on the front of the vehicle. To keep the ICC system operating properly, be sure to observe the following: Always keep the sensor area clean. Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on ...

Unit disassembly and assembly
FRONT DRIVE SHAFT Disassembly and Assembly (LH) Circlip Dust shield Housing  Snap ring Spider assembly Stopper ring  Boot band  Boot  Shaft  Damper band  Dynamic damper  Circlip . Joint sub-assembly : Wheel side : Fill us ...

P0138, P0158 HO2S2
Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal ...