Drive belts*:
Check engine drive belts for wear, fraying or cracking and for proper tension. Replace any damaged drive belts.
Engine air filter:
Replace at specified intervals. When driving for prolonged periods in dusty conditions, check/replace the filter more frequently.
Engine coolant*:
Replace coolant at the specified interval. When adding or replacing coolant, be sure to use only Genuine NISSAN Long Life Antifreeze/Coolant (blue) or equivalent with the proper mixture. (For additional information on the proper mixture for your area, refer to "Engine cooling system" in the "Do-it-yourself" section of this manual.) NOTE: Mixing any other type of coolant or the use of non-distilled water may reduce the recommended service interval of the coolant.
Engine oil and oil filter:
Replace engine oil and oil filter at the specified intervals. For recommended oil grade and viscosity refer to "Recommended fluids/lubricants and capacities" in the "Technical and consumer information" section of this manual.
Fuel lines*:
Check the fuel hoses, piping and connections for leaks, looseness, or deterioration. Tighten connections or replace parts as necessary.
Spark plugs:
Replace at specified intervals. Install new plugs of the same type as originally equipped.
Explanation of scheduled maintenance items
Chassis and Body MaintenanceInterior trunk access
The trunk can be accessed from the passenger
side of the rear seat.
The rear seat can be locked using the mechanical
key to prevent unauthorized access. For additional
information, refer to "Keys" in this section.
1. Move the front passenger seat to the most
forward position.
2. Open th ...
STRG branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor
for damage, bend and loose connection
(unit side and connector side).
2.CHECK HARNESS FOR OPE ...
Microphone signal circuit
Description
Voice signals are transmitted from the microphone to the Bluetooth control
unit using the microphone signal circuits.
Diagnosis Procedure
1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL UNIT AND MICROPHONE
Turn ignition switch OFF.
Disconnect Bluetooth control unit connector and ...