Nissan Maxima Service and Repair Manual: Service data and specifications (SDS)

Removal and installation

STARTER MOTOR Removal and Installation REMOVAL Remove the battery tray. Refer to PG-68, "Removal and Installation (Battery Tray)".  Disconnect the battery cable (A) and starter harne ...

Accelerator control system

...

Other materials:

Changing engine oil filter
1. Park the vehicle on a level surface and apply the parking brake. 2. Turn the engine off. 3. Place a large drain pan under the oil filter B . 4. Remove clips A from the right engine protector located inside the right wheel well and then remove protector. Remove oil filter B with an ...

Key slot
Diagnosis Procedure Regarding Wiring Diagram information, refer to SEC-147, "Wiring Diagram" or SEC-128, "Wiring Diagram". 1.CHECK KEY SLOT POWER SUPPLY CIRCUIT  Turn ignition switch OFF.  Disconnect key slot connector.  Check voltage between slot harness co ...

P0703 brake switch B
Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the TCM via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: Immediately after perform ...