Nissan Maxima Service and Repair Manual: Front lower link

Removal and Installation

Removal

  1. Remove the front lower link nut and bolt from the rear axle housing using power tools.
  2. Remove the adjusting bolt and nut from the rear suspension member using power tools.
  3. Remove the front lower link.

Nissan Maxima. FRONT LOWER LINK

Installation

Installation is in the reverse order of removal.

CAUTION: Do not reuse the adjusting nut. Check the wheel alignment. Adjust as necessary.

    Shock absorber
    Removal and Installation REMOVAL Remove the rear wheel and tire using power tool. Refer to WT-60, "Adjustment". Set a jack under rear lower link to relieve the rear suspension spring te ...

    Radius rod
    Removal and Installation Removal Remove the rear wheel and tire using power tool. Refer to WT-60, "Adjustment". Remove the radius rod nut and bolt from the rear axle housing using power t ...

    Other materials:

    Intelligent key interlock function
    INTELLIGENT KEY INTERLOCK FUNCTION : System INTELLIGENT KEY INTERLOCK FUNCTION : System Description OUTLINE When unlocking doors by using Intelligent Key or door request switch (driver side), seat slide and steering tilt move directly to the exit assist function. Other loads move to the ...

    B2604 transmission range switch
    Description BCM confirms the shift position with the following 4 signals.  CVT selector lever  Transmission range switch  P position signal from IPDM E/R (CAN)  P position signal from TCM (CAN) DTC Logic DTC DETECTION LOGIC NOTE: I ...

    Symptom diagnosis
    SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer' ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0085