Nissan Maxima Service and Repair Manual: Control unit

Removal and installation

...

Ambient sensor

Removal and Installation REMOVAL From under the vehicle, disconnect the harness connector from the ambient sensor. Release the two ambient sensor clips and remove the ambient sensor (1). ...

Other materials:

Installing the spare tire
The spare tire is designed for emergency use. For additional information, refer to "Wheels and tires" in the "Do-it-yourself" section of this manual. 1. Clean any mud or dirt from the surface between the wheel and hub. 2. Carefully put the spare tire on and tighten the wheel nuts finger ...

B2617 starter relay circuit
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2617 is displ ...

Cooling and/or dehumidified heating (AUTO)
This mode may be used all year round as the system automatically works to keep a constant temperature. Air flow distribution and fan speed are also controlled automatically. 1. Press the AUTO button on. 2. Turn the temperature control dial to the left or right to set the desired temperatur ...