Preparation
Control unitIgnition signal
Description
The ignition signal from the ECM is sent to and amplified by the power
transistor. The power transistor turns
ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the
proper high voltage in the coil
secondary circuit.
Component Function Check
1.INSPECTIO ...
Power supply and ground circuit
BCM
BCM : Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuses or fusible link are blown.
2. CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect BCM.
Check voltage between BCM harness connector and ground.
3. CHECK GROUND CIRCUIT
Che ...
Body side trim
Exploded View
Front pillar finisher
Dash side lower finisher
Front kicking plate
Front sill cover
Center pillar lower finisher
Rear sill cover
Rear kicking plate
Rear body side welt
Rear pillar finisher
Screw cover
Center pillar upper finisher
Front seat belt adju ...