Nissan Maxima Service and Repair Manual: In-vehicle sensor

Ambient sensor

Removal and Installation REMOVAL From under the vehicle, disconnect the harness connector from the ambient sensor. Release the two ambient sensor clips and remove the ambient sensor (1). ...

Sunload sensor

Removal and Installation REMOVAL Remove the front LH speaker grille from the instrument panel. Refer to IP-10, "Exploded View". Disconnect the harness connector from the sunload se ...

Other materials:

Audio antenna
Location of Antenna Audio unit Audio unit antenna feeder In-line connectors M103, M501 Antenna amp. Window antenna Satellite radio tuner Satellite radio antenna feeder Satellite radio antenna Window Antenna Repair ELEMENT CHECK Attach probe circuit tester (ohm sett ...

P1805 brake switch
Description Brake switch signal is applied to the ECM via the stop lamp switch when the brake pedal is depressed. This signal is used mainly to decrease the engine speed when the vehicle is being driver. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATI ...

Brake booster
Inspection OPERATION With engine stopped, change vacuum to atmospheric pressure by depressing brake pedal several times. Then with brake pedal fully depressed, start engine and when vacuum pressure reaches the standard, make sure that clearance between brake pedal and floor panel decreas ...