Nissan Maxima Service and Repair Manual: Sunload sensor

Removal and Installation

REMOVAL

  1. Remove the front LH speaker grille from the instrument panel. Refer to IP-10, "Exploded View".
  2. Disconnect the harness connector from the sunload sensor.
  3. Release the sunload sensor tabs and remove the sunload sensor (1) from the front LH speaker grille.

Nissan Maxima. SUNLOAD SENSOR

INSTALLATION

Installation is in the reverse order of removal.

    In-vehicle sensor
    Removal and Installation REMOVAL Remove the instrument lower panel LH. Refer to IP-19, "Removal and Installation". Remove the in-vehicle sensor screw and the in-vehicle sensor. ...

    Intake sensor
    Removal and Installation REMOVAL Remove the evaporator (2). Refer to HA-48, "EVAPORATOR: Removal and Installation". Release the intake sensor clip (A), then remove the intake sens ...

    Other materials:

    DTC/circuit diagnosis
    POWER SUPPLY AND GROUND CIRCUIT COMBINATION METER COMBINATION METER : Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-87, "Wiring Diagram". 1.CHECK FUSES Check for blown combination meter fuses. 2.POWER SUPPLY CIRCUIT CHECK Disconnect combination meter connector. ...

    Clip list
    Descriptions for Clips Replace any clips which are damaged during removal or installation. ...

    SRS air bag system
    "AIR BAG" Warning Lamp Does Not Turn Off DIAGNOSTIC PROCEDURE 1.CHECK CONDITION OF AIR BAG MODULE Inspect for any deployed air bag modules or seat belt pre-tensioners. 2.CHECK THE AIR BAG FUSE Check 10A fuse [No. 2, located in the fuse block (J/B)]. 3.CHECK AIR BAG FUSE AGAIN Replace 10A fuse ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0118