Nissan Maxima Service and Repair Manual: Refrigerant pressure sensor

Removal and Installation

REMOVAL

  1. Discharge the refrigerant. Refer to HA-28, "Recycle Refrigerant".
  2. Remove the core support upper cover.
  3. Disconnect the harness connector from the refrigerant pressure sensor.
  4. Remove the refrigerant pressure sensor.

CAUTION: Cap or wrap the opening of the refrigerant pressure sensor with suitable material such as vinyl tape to avoid the entry of air.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Do not reuse O-ring.
  • Apply A/C oil to the O-ring of the refrigerant pressure sensor for installation.
  • After charging refrigerant, check for leaks.
    Intake sensor
    Removal and Installation REMOVAL Remove the evaporator (2). Refer to HA-48, "EVAPORATOR: Removal and Installation". Release the intake sensor clip (A), then remove the intake sens ...

    Door motor
    Exploded View Heating and cooling unit assembly Mode door motor Air mix door motor (driver side) Air mix door motor (passenger side) Intake door motor INTAKE DOOR MOTOR INTAKE D ...

    Other materials:

    Precaution
    PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to ...

    Parking, license plate and tail lamps system
    Wiring Diagram ...

    P1612 chain of ECM-IMMU
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON. DTC Logic DTC DETECTION LOGIC ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0079