The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed. For additional information, refer to "Reprogramming a single HomeLink button" in this section.
To clear all programming: 1. Press and hold the two outer HomeLink buttons until the indicator light begins to flash in approximately 10 seconds. Do not hold for longer than 20 seconds.
2. Release both buttons.
HomeLink is now in the programming mode and can be programmed at any time beginning with "Programming HomeLink" - Step 1.
Programming trouble-diagnosis
Reprogramming a single HomeLink buttonGeneral maintenance
General maintenance includes those items which
should be checked during normal day-to-day operation.
They are essential for proper vehicle operation.
It is your responsibility to perform these
procedures regularly as prescribed.
Performing general maintenance checks requires
minimal mech ...
Front door speaker
Description
The audio unit sends audio signals to the front door speakers using the front
door speaker circuits.
Diagnosis Procedure
1.CONNECTOR CHECK
Check the audio unit and speaker connectors for the following:
Proper connection
Damage
Disconnected or loose terminals
...
P0725 engine speed
Description
The engine speed signal is transmitted from ECM to TCM via CAN communication
line.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn
igni ...