Description
Refer to LAN-24, "CAN Communication Signal Chart".
DTC Logic
DTC DETECTION LOGIC
| DTC | Trouble diagnosis name | DTC detecting condition | Possible cause |
| U1000 | CAN COMM CIRCUIT |
|
|
DTC CONFIRMATION PROCEDURE
1. STEP 1
Turn ignition switch ON and wait at least 3 seconds.
2. STEP 2
Check "Self diagnostic result" with CONSULT.
Is the DTC detected?
Diagnosis Procedure
Refer to LAN-15, "Trouble Diagnosis Flow Chart".
Special Repair Requirement
Refer to Owner's Manual.
U1010 control unit (CAN)Recommended fluids and lubricants
FOR USA AND CANADA
FOR USA AND CANADA : Fluids and Lubricants
*1: For further details, see "Engine Oil Recommendation".
*2: NISSAN recommends Genuine NISSAN Ester Oil available at a NISSAN dealer.
*3: Use only Genuine NISSAN CVT Fluid NS-2. Using transmission fluid other than
Genuine NIS ...
P0605 ECM
Description
The ECM consists of a microcomputer and connectors for signal
input and output and for power supply. The ECM controls the engine
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always ...
Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver
button, complete the following:
1. Press and hold the desired HomeLink button.
DO NOT release the button.
2. The indicator light will begin to flash after
20 seconds. Without releasing the
HomeLink button, proceed with "Programming
HomeLink" - ...