Symptom Table
Engine cannot be started with all Intelligent Keys.
CAUTION:
Follow Trouble Diagnosis Flowchart referring to "SEC-4, "Work Flow"". Determine malfunctioning condition before performing this diagnosis.
Check that vehicle is under the condition shown in "Conditions of vehicle" before starting diagnosis.
Check systems shown in the "Diagnosis/service procedure" column in this order.
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
Engine start function is ON when setting on CONSULT.
Use Intelligent Key with registered Intelligent Key ID.
One or more of Intelligent Keys with registered Intelligent Key ID is in the passenger compartment.

Vehicle security system symptomsInstrument Panel
Vent
Headlight/fog light/turn signal switch
Supplemental front-impact air bag. Horn
Meters and gauges. Warning and indicator lights. Vehicle information
display
Paddle shifters (if so equipped)
Wiper and washer switch
Audio controls*. Navigation controls*
Hazard warning ...
U1010 control unit (CAN)
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1. REPLACE BCM
When DTC [U1010] is detected, replace BCM.
Special Repair Requirement
1. REQUIRED WORK WHEN REPLACING BCM
Initialize NVIS by CONSULT. For the details of initialization refer to
CONSULT Immobilizer mode and follow
the on ...
HVAC branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the A/C auto amp. for
damage, bend and loose connection (unit
side and connector side).
2.CHECK HARNESS FOR OPEN CIRCUI ...