Nissan Maxima Service and Repair Manual: Security control system

Outside key antenna

REAR BUMPER REAR BUMPER : Removal and Installation REMOVAL Remove the rear bumper. Refer to EXT-17, "Removal and Installation". Disconnect harness connector (1) from the outsid ...

Basic inspection

...

Other materials:

Antenna AMP
Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-23, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors (B) from the antenna amp. (1). Remove the antenna amp. screw (C) and the antenna amp. (1). INSTALLAT ...

U1010 control unit (CAN)
Description Refer to LAN-24, "CAN Communication Signal Chart". DTC Logic DTC DETECTION LOGIC DTC No. Trouble diagnosis name DTC detecting condition Possible cause U1010 CONTROL UNIT (CAN When detecting error during the initial diagnosis of CAN controller of dri ...

Brake pedal
Exploded View Clevis pin Snap pin Stop lamp switch ASCD cancel switch Clip Brake pedal assembly Brake pedal pad NOTE: The clevis pin must be installed from the RH side as shown. Removal and Installation REMOVAL Remove instrument lower panel LH and lower knee protec ...