Nissan Maxima Service and Repair Manual: ECU diagnosis information

Vehicle security indicator

Description  Vehicle security indicator is built in combination meter.  NVIS (Nissan Vehicle Immobilizer System-NATS) and vehicle security system conditions are indicate ...

BCM (body control module)

Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and dis ...

Other materials:

Emission control system maintenance
Abbreviations: I = Inspect and correct or replace as necessary, R = Replace, D = Drain water NOTE: (1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000 miles (16,000 km) or 12 months. Replace the drive belts if found damaged. (2) If operating mainly in dusty condit ...

B2636, B2637, B2638, B2639, B2654, B2655 mode door motor
Description COMPONENT DESCRIPTION Mode Door Motor The mode door motor (1) is attached to the heater & cooling unit assembly. It rotates so that air is discharged from the outlet set by the A/C auto amp. Motor rotation is conveyed to a link which activates the mode door DT ...

C1145, C1146 yaw rate/side/decel G sensor
Description The yaw rate/side/decel G sensor detects the yaw rate/side/decel G affecting the vehicle, and transmits the data to the ABS actuator and electric unit (control unit) as an analog voltage signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSI ...