Nissan Maxima Service and Repair Manual: Wiring diagram

IPDM E/R (intelligent power distribution module engine room)

Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Fail Safe CAN COMMUNICATION CONTROL When CAN communication with ECM and BCM is impossible, IPDM E/R ...

NVIS

Wiring Diagram               ...

Other materials:

Interior room lamp
Removal and Installation FRONT ROOM/MAP LAMP ASSEMBLY Removal Release the metal clips and drop front edge of front room/map lamp assembly (1) away from headlining. Slide front room/map lamp assembly forward in vehicle to clear pawls at rear. : Front : Pawl : Metal clip Disco ...

Front door speaker
Removal and Installation REMOVAL Remove the front door finisher. Refer to INT-18, "Removal and Installation". Remove the front door speaker screws (A). Disconnect the harness connector from the front door speaker (1) and remove. Remove the front door speaker spacer screws (B) and ...

P0840 transmission fluid pressure SEN/SW A
The secondary pressure sensor detects secondary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds b ...