Low Tire Pressure Warning Lamp Does Not Come On When Ignition Switch Is Turned On
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
DIAGNOSTIC PROCEDURE
1.SELF-DIAGNOSTIC RESULT CHECK
Using CONSULT, check display contents of BCM in SELF-DIAGNOSIS.
2.CHECK COMBINATION METER
Check combination meter operation
3.CHECK LOW TIRE PRESSURE WARNING LAMP
Disconnect BCM harness connector.
TPMS
Low tire pressure warning lamp stays onDaytime running light system
System Diagram
System Description
The headlamp system for Canada vehicles is equipped with a daytime light
relay that activates the high beam headlamps at approximately half
illumination whenever the engine is running. If the parking brake is
depressed before the engine is started, the day ...
P0456 evap control system
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0456 is displayed with DTC P0442, first perform the trouble diagnosis
for DTC P0456.
This diagnosis detects very small leakage in the EVAP line between fuel tank
and EVAP canister purge volume
control solenoid valve, using the intake manifold va ...
Reclining switch
Description
Reclining switch is equipped to the power seat switch LH on the seat frame.
The operation signal is input to the driver seat control unit when the
reclining switch is operated.
Component Function Check
1.CHECK FUNCTION
Select "RECLN SW-FR", "RECLN SW-RR" in "DATA MONITOR" mode ...