Nissan Maxima Service and Repair Manual: TPMS

Symptom Table

Symptom

  • Low tire pressure warning lamp does not come on when ignition switch is turned ON. WT-50
  • Low tire pressure warning lamp stays on when ignition switch is turned ON. WT-51
  • Low tire pressure warning lamp flashes when ignition switch is turned ON. WT-52
  • Hazard warning lamps flash when ignition switch is turned ON. WT-53
  • ID registration cannot be completed.
    Symptom diagnosis
    ...

    Low tire pressure warning lamp does not turn on
    Low Tire Pressure Warning Lamp Does Not Come On When Ignition Switch Is Turned On NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech ...

    Other materials:

    P1611 ID discord, IMMU-ECM
    Description BCM performs the ID verification with ECM that allows the engine to start. Start the engine if the ID is OK. ECM prevents the engine from starting if the ID is not registered. BCM starts the communication with ECM if ignition switch is turned ON. DTC Logic DTC DETECTION LOGIC ...

    ADP branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF.  Disconnect the battery cable from the negative terminal.  Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). ...

    Precaution
    PRECAUTIONS Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and fron ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.006