Nissan Maxima Service and Repair Manual: Low tire pressure warning lamp stays on

Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On

DIAGNOSTIC PROCEDURE

1.CHECK BCM CONNECTORS

  1. Turn ignition switch OFF.
  2. Disconnect BCM harness connectors.
  3. Check terminals for damage or loose connections.

2.CHECK BCM POWER SUPPLY AND GROUND CIRCUITS

    Low tire pressure warning lamp does not turn on
    Low Tire Pressure Warning Lamp Does Not Come On When Ignition Switch Is Turned On NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech ...

    Low tire pressure warning lamp blinks
    Low Tire Pressure Warning Lamp Flashes When Ignition Switch Is Turned On NOTE: If low tire pressure warning lamp flashes as shown, the system is normal. Flash Mode A  This mode show ...

    Other materials:

    Clip list
    Descriptions for Clips Replace any clips which are damaged during removal or installation. ...

    Exterior rear
    Rear window defroster switch High-mounted stop light Interior trunk lid release. Trunk lid Exterior trunk lid release/request button. Rearview camera Rear sonar sensors (if so equipped) Replacing bulbs Fuel-filler door.  Fuel recommendation Child safety rear door locks R ...

    Electronic controlled engine mount
    Description In the idle range, ECM turns OFF the electronically-controlled engine mount control solenoid valve and applies manifold pressure to the electronically controlled engine mount. This decreases damping force of the electronically- controlled engine mount and absorbs vibrations trav ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0099