Nissan Maxima Service and Repair Manual: B2268 water temp

B2267 engine speed

Description The engine speed signal is transmitted from ECM to the combination meter via CAN communication. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS OF ECM ...

Power supply and ground circuit

COMBINATION METER COMBINATION METER : Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-87, "Wiring Diagram". 1.CHECK FUSES Check for blown combination meter fuses. 2.POWER ...

Other materials:

Main line between DLC and HVAC circuit
Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Disconnect the following harness connectors. ECM A/C auto amp. Check the continuity between the data link connector and the A/C ...

Maintenance under severe operating conditions
Severe driving conditions The maintenance intervals shown on the preceding pages are for normal operating conditions. If the vehicle is mainly operated under severe driving conditions as shown below, more frequent maintenance must be performed on the following items as shown in the table. ...

Steering gear and linkage
Exploded View Cotter pin Steering gear assembly Front Removal and Installation NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling. REMOVAL Remove front wheel and tire using power tool. Refer to WT-60, "Adjus ...