Nissan Maxima Service and Repair Manual: Removal and installation

Preparation

PREPARATION Special Service Tool ...

Key slot

Removal and Installation REMOVAL  Remove the instrument lower panel LH. Refer to IP-19, "Removal and Installation".  Remove the switch assembly screws (A), remove the k ...

Other materials:

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2608 is displ ...

ECM branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - Models without automatic drive positione ...

Heated seat switches (if so equipped)
The front seats are warmed by built-in heaters. 1. Start the engine. 2. Push the LO or HI position of the switch, as desired. The indicator light in the switch will illuminate. The heater is controlled by a thermostat, automatically turning the heater on and off. The indicator light ...