Nissan Maxima Service and Repair Manual: Does not stop fully-open or fully-closed position

Auto operation does not operate

Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. ...

Retained power operation does not operate properly

Diagnosis Procedure 1. CHECK FRONT DOOR SWITCH Check front door switch. ...

Other materials:

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2608 is displ ...

Measurement of weights
Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the gross axle weight ratings ( ...

Illumination
Removal and Installation TRUNK ROOM LAMP Removal Release the tab (A), then swing open the lens. : Front Remove the bulb (3). Release the tab (B), then pull trunk room lamp (2) away from body opening. Disconnect the connector (1) and remove trunk room lamp Installation Install ...