Nissan Maxima Service and Repair Manual: Symptom diagnosis

Wiring diagram

SUNROOF SYSTEM Wiring Diagram ...

Sunroof does not operate properly

Diagnosis Procedure 1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. 2. CHECK SUNROOF MOTOR ASSEMBLY POWER SUPPLY AND GROUND CIRCUIT Check sunroof motor asse ...

Other materials:

CVT fluid
Inspection CHECKING CVT FLUID The fluid level should be checked with the fluid warmed up to 50 to 80C (122 to 176F). The fluid level check procedure is as follows:  Check for fluid leakage.  With the engine warmed up, drive the vehicle in an urban area. When amb ...

Tire pressure receiver
Removal and Installation REMOVAL Remove instrument lower panel LH. Refer to IP-11, "Removal and Installation". Locate tire pressure receiver (1) to the right of the steering column and disconnect the harness connector from the tire pressure receiver. Remove tire pressure receiver ...

Headlamp (HI) circuit
Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp high relay based on inputs from the BCM over the CAN communication lines. When the headlamp high relay is energized, power flows through fuses 48 and 49, located in the IPDM E/R. Power then flow ...