Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Retained power operation does not operate properly
Squeak and rattle trouble diagnosesRemoval and Installation
REMOVAL
Disconnect the battery negative terminal. Refer to PG-67, "Removal
and Installation (Battery)".
Disconnect the harness connector from the accelerator position
sensor.
Remove the three accelerator pedal nuts.
Remove the accelerator pedal and accelerator position sensor assembl ...
NISSAN Intelligent Key
1. Intelligent Keys (two sets)
2. Mechanical keys
3. Key number plate (one plate)
Your vehicle can only be driven with the Intelligent
Keys which are registered to your vehicle's Intelligent
Key System components.
Never leave these keys in the vehicle.
As many as four Intelligent Keys can ...
Disk eject signal circuit
Description
The eject signal is output to AV control unit when the eject switch of A/C
and AV switch assembly is pressed.
Diagnosis Procedure
1.CHECK CONTINUITY DISK EJECT SIGNAL CIRCUIT
Turn ignition switch OFF.
Disconnect A/C and AV switch assembly connector M98 and AV
control un ...