Description
The parking, license plate and tail lamps do not turn ON in with any lighting switch setting.
Diagnosis Procedure
1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION
Check the combination switch (lighting and turn signal switch).
2.CHECK TAIL LAMP RELAY REQUEST SIGNAL INPUT
CONSULT DATA MONITOR

3.PARK LAMP CIRCUIT INSPECTION
Check the parking lamp circuit
Both side headlamps (LO) are not turned on
Both side front fog lamps are not turned onThe ICC switch
The system is operated by the
CRUISE switch and four control
switches,
all mounted on the steering wheel.
1. DISTANCE switch:
Changes the vehicle's following distance:
Long
Middle
Short
2. RES+ switch:
Resumes set speed or increases speed incrementally.
3. CANCEL switch:
D ...
Emission control system maintenance
Abbreviations: I = Inspect and correct or replace as necessary, R =
Replace, D = Drain water
NOTE:
(1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000
miles (16,000 km) or 12 months. Replace the drive belts if found
damaged.
(2) If operating mainly in dusty condit ...
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 2,000 rpm under no load (for example, the
selector lever position is P or N and
engine speed is over 2,000 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
...