Nissan Maxima Service and Repair Manual: Both side headlamps (LO) are not turned on

Both side headlamps do not switch to high beam

Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) ...

Parking, license plate and tail lamps are not turned on

Description The parking, license plate and tail lamps do not turn ON in with any lighting switch setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) INSPECTION Ch ...

Other materials:

ECU diagnosis information
POWER STEERING CONTROL UNIT Reference Value TERMINA LAYOUT PHYSICAL VALUES CAUTION: When using circuit tester or oscilloscope to measure voltage for inspection, be sure not to extend forcibly any connector terminals. Fail Saf EPS system EPS system enters the fail-safe mode (that al ...

Evaporative emission system
System Diagram System Description *1: ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to the ECM via the CAN communication line. SYSTEM DESCRIPTION The evaporative emission system is used to reduce hydrocarbons emitte ...

Tel antenna
Removal and Installation REMOVAL Disconnect the battery negative terminal. Refer to PG-67, "Removal and Installation (Battery)". Remove the rear parcel shelf finisher. Refer to INT-28, "Removal and Installation". Remove the Bluetooth antenna screw (A). Detach the ...