Nissan Maxima Service and Repair Manual: Both side headlamps do not switch to high beam

Normal operating condition

Description XENON HEADLAMP The brightness and color of the light may vary slightly immediately after turning the headlamp ON. This condition will remain until the xenon bulb becomes stable. ...

Both side headlamps (LO) are not turned on

Description The headlamps (both sides) do not turn ON in any lighting switch setting. Diagnosis Procedure 1.CHECK COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) Check the combination switch ...

Other materials:

Pedal vibration or abs operation sound occurs
Diagnosis Procedure CAUTION: Under the following conditions, ABS is activated and vibration is felt when brake pedal is lightly depressed (just place a foot on it).However, this is normal.  When shifting gears  When driving on slippery road  During cornering at high spe ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused b ...

Inspection and adjustment
ECM RE-COMMUNICATING FUNCTION ECM RE-COMMUNICATING FUNCTION : Description the ECM has been replaced with a new one (*1). *1: New one means an ECM which has never been energized on-board. (In this step, initialization procedure by CONSULT is not necessary) NOTE: When registering new Key ...