Nissan Maxima Service and Repair Manual: Normal operating condition

Nissan Maxima Service and Repair Manual / Driver controls / Exterior lighting system / Symptom diagnosis / Normal operating condition

Description

XENON HEADLAMP

  • The brightness and color of the light may vary slightly immediately after turning the headlamp ON. This condition will remain until the xenon bulb becomes stable. This is normal.
  • Illumination time lag may occur between right and left. This is normal.

AUTO LIGHT SYSTEM

The auto light system may not turn the headlamp ON/OFF immediately after passing a dark area or a bright area (short tunnel, sky bridge, shadowed area etc.). This is normal.

    Exterior lighting system symptoms
    Symptom Table CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. ...

    Both side headlamps do not switch to high beam
    Description The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting. Diagnosis Procedure 1.COMBINATION SWITCH (LIGHTING AND TURN SIGNAL SWITCH) ...

    Other materials:

    P1550 battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures ...

    Tel antenna
    Removal and Installation REMOVAL Disconnect the battery negative terminal. Refer to PG-67, "Removal and Installation (Battery)". Remove the rear parcel shelf finisher. Refer to INT-28, "Removal and Installation". Remove the Bluetooth antenna screw (A). Detach the Bluetooth antenna ...

    Auto light system
    Wiring Diagram ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0076