Nissan Maxima Owners Manual: Tilt and telescopic operation

To adjust the steering wheel move the switch 1 in the following directions:

  • Adjust the steering wheel up or down in direction 2 to the desired tilt position.
  • Adjust the steering wheel forward or backward in direction 3 to the desired telescopic position.

CAUTION

For vehicles with automatic drive positioner: Failure to reset the tilt and telescoping functions of the steering wheel, after the vehicle's battery has been discharged, may prevent the steering wheel position from being adjusted.

For vehicles with automatic drive positioner: Both the tilt and telescopic steering operation must be reset after the vehicle's battery has been discharged in order to prevent the tilt and telescopic operation from locking in one position. When the battery has been recharged or replaced, perform the following:

  • For tilt operation: Adjust the switch 1 so the steering wheel moves to the highest position 2 that can be reached.
  • For telescopic operation: Adjust the switch 1 so the steering wheel moves to the most forward and backward position 3 that can be reached.

Performing these operations resets the range of the steering wheel's tilt and telescopic function.

    Automatic operation (if so equipped)
    ...

    Entry/Exit function (if so equipped)
    The automatic drive positioner system will make the steering wheel move up automatically when the driver's door is opened and the ignition switch is in the LOCK position. This lets the driver get ...

    Other materials:

    P0102, P0103 MAF sensor
    Description The mass air flow sensor (1) is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. The mass air flow sensor controls the temperature of the hot wire to a certain amount. The heat generated by the hot wire is re ...

    Headlamp (LO) circuit
    Description The IPDM E/R (intelligent power distribution module engine room) controls the headlamp low relay based on inputs from the BCM over the CAN communication lines. When the headlamp low relay is energized, power flows through fuses 51 and 52, located in the IPDM E/R. Power then flows ...

    Auto light system
    System Diagram System Description BCM (Body Control Module) controls auto light operation according to signals from optical sensor, lighting switch and ignition switch. IPDM E/R (Intelligent Power Distribution Module Engine Room) operates parking, license plate, tail, front fog lamps ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.0126