Nissan Maxima Service and Repair Manual: ECU diagnosis information

Washer motor circuit

Diagnosis Procedure 1. CHECK FRONT WASHER MOTOR FUSE Turn the ignition switch OFF. Check that the following fuse is not blown. 2. CHECK FRONT WASHER MOTOR POWER SUPPLY Disconnect fro ...

BCM (body control module)

Reference Value NOTE:The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech IIUser Guide for additional information. Activate and display T ...

Other materials:

Power supply and ground circuit
BCM BCM : Diagnosis Procedure 1. CHECK FUSE AND FUSIBLE LINK Check if the following BCM fuses or fusible link are blown. 2. CHECK POWER SUPPLY CIRCUIT Turn ignition switch OFF. Disconnect BCM. Check voltage between BCM harness connector and ground. 3. CHECK GROUND CIRCUIT Che ...

System maintenance
The sensor for the ICC system A is located on the front of the vehicle. To keep the ICC system operating properly, be sure to observe the following: Always keep the sensor area clean. Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on ...

Continuously Variable Transmission (CVT) fluid
CAUTION NISSAN recommends using Genuine NISSAN CVT Fluid NS-3 (or equivalent) ONLY in NISSAN CVTs. Do not mix with other fluids. Do not use Automatic Transmission Fluid (ATF) or Manual transmission fluid in a NISSAN CVT, as it may damage the CVT. Damage caused by the use of fluid ...