Description
The fuel gauge needle will not move to "F" position when refueling.
Diagnosis Procedure
1.OBSERVE FUEL GAUGE
Does it take a long time for the pointer to move to FULL position?
2.IDENTIFY FUELING CONDITION
Was the vehicle fueled with the ignition switch ON?
3.OBSERVE VEHICLE POSITION
Is the vehicle parked on an incline?
4.OBSERVE FUEL GAUGE POINTER
The fuel gauge pointer does not move
The oil pressure warning lamp does not turn onAudio antenna
Location of Antenna
Audio unit
Audio unit antenna feeder
In-line connectors M103, M501
Antenna amp.
Window antenna
Window Antenna Repair
ELEMENT CHECK
Attach probe circuit tester (ohm setting) to antenna terminal on
each side
When measuring continuity, wrap tin ...
Main line between DLC and HVAC circuit
Diagnosis Procedure
1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect the following harness connectors.
ECM
A/C auto amp.
Check the continuity between the data link connector and the A/C ...
B2268 water temp
Description
The engine coolant temperature signal is transmitted from ECM to the
combination meter via CAN communication.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS OF ECM
Perform "Self Diagnosis Result" of ECM, and repair or replace malfunctioning
parts.
...