Description
The oil pressure warning lamp stays off when the ignition switch is turned ON.
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform IPDM E/R auto active test. Refer to PCS-11, "Diagnosis Description".
2.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT
Check the oil pressure switch signal circuit. Refer to MWI-42, "Diagnosis Procedure".
3.CHECK OIL PRESSURE SWITCH UNIT
Perform a unit check for the oil pressure switch. Refer to MWI-42, "Component Inspection".
The fuel gauge pointer does not move to "F" when refueling
The oil pressure warning lamp does not turn offVents
Side
Adjust air flow direction by moving the vent
slides.
Open or close the vents by using the dial. Move
the dial toward the to open
the vents or
toward the to close them.
Center
Rear (center console) ...
Power supply and ground circuit
CLIMATE CONTROLLED SEAT CONTROL UNIT
CLIMATE CONTROLLED SEAT CONTROL UNIT : Diagnosis Procedure
Regarding Wiring Diagram information, refer to SE-44, "Wiring Diagram".
1.CHECK FUSES
2.CHECK BATTERY POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect climate controlled seat control ...
Oil cooler
Removal and Installation
Oil filter
Oil cooler bolt
Water pipe
Water hose
Oil cooler
O-ring
Oil pan
Water pipe
Relief valve
Water drain plug
Copper gasket
Water connector Engine coolant flow
WARNING: Be car ...