Nissan Maxima Service and Repair Manual: Steering switch

Removal and Installation

REMOVAL

Nissan Maxima. REMOVAL

  1. Remove the driver airbag module. Refer to SR-12, "Removal and Installation".
  2. Remove the steering wheel audio control switch screws (A).
  3. Release the steering wheel audio control switch harness clips (B).
  4. Remove the steering wheel audio control switches (1).

INSTALLATION

Installation is in the reverse order of removal.

    Bose speaker amp
    Removal and Installation Bose speaker amp. Bose speaker amp. screws REMOVAL NOTE: If removing the BOSE speaker amp. bracket, it is necessary to remove the parcel shelf finisher. The B ...

    Audio antenna
    Location of Antenna Audio unit Audio unit antenna feeder In-line connectors M103, M501 Antenna amp. Window antenna Satellite radio tuner Satellite radio antenna feeder Satelli ...

    Other materials:

    Unit removal and installation
    EPS CONTROL UNIT Removal and Ins REMOVAL Disconnect negative battery terminal. Refer to PG-67, "Removal and Installation (Battery)". Remove audio display unit. Refer to AV-73, "Removal and Installation" (BASE AUDIO), AV-161, "Removaland Installation" (BOSE W/MONOCHROME DISPLAY), A ...

    Troubleshooting guide
    Verify the location of all Intelligent Keys that are programmed for the vehicle. If another Intelligent Key is in range or inside the vehicle, the vehicle system may respond differently than expected. Symptom Possible Cause Remedy When pushing the ignition switch to sto ...

    P0840 transmission fluid pressure SEN/SW A
    The secondary pressure sensor detects secondary pressure of CVT and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF. Then wait at least 10 seconds b ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2026 Copyright www.nimainfo.com
    0.009