Nissan Maxima Service and Repair Manual: U1200 AV control unit

U1010 control unit (CAN)

Description Initial diagnosis of AV control unit. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.REPLACE AV CONTROL UNIT ...

U1216 AV control unit

Description Part name  Description  AV CONTROL UNIT  It is the master unit of the MULTI AV system and it is connected to each control unit by means ...

Other materials:

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2608 is displ ...

IPDM-E branch line circuit
Diagnosis Procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the IPDM E/R for damage, bend and loose connection (unit side and connector side). 2.CHECK HARNESS FOR OPEN CIRCUIT ...

Rear spoiler
Exploded View Rear spoiler assembly High-mounted stop lamp harness connector Harness grommet Removal and Installation Removal Remove trunk lid finisher. Refer to INT-36, "Removal and Installation". Disconnect the harness connector (1) from the high-mounted stop lamp. Remo ...