Nissan Maxima Service and Repair Manual: Microphone

Antenna AMP.

Removal and Installation REMOVAL Remove the rear pillar finisher RH. Refer to INT-36, "Exploded View". Detach the antenna amp. harness clip (A). Disconnect the harness connectors ...

Tel antenna

Removal and Installation REMOVAL Disconnect the battery negative terminal. Refer to PG-67, "Removal and Installation (Battery)". Remove the rear parcel shelf finisher. Refer to INT ...

Other materials:

P0605 ECM
Description The ECM consists of a microcomputer and connectors for signal input and output and for power supply. The ECM controls the engine DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always ...

NISSAN vehicle immobilizer system-nats symptoms
Symptom Table Security indicator does not turn ON or flash. CAUTION:  Follow Trouble Diagnosis Flowchart referring to "SEC-4, "Work Flow"". Determine malfunctioning condition before performing this diagnosis.  Check that vehicle is under the condition shown in "Co ...

Aux in jack
Removal and Installation REMOVAL Remove the center console. Refer to IP-14, "Removal and Installation". Remove the center console bin box. Remove the auxiliary input jacks screws (A), then remove the auxiliary input jacks (1). INSTALLATION Installation is in the reverse order of ...