Nissan Maxima Service and Repair Manual: Center speaker

Front tweeter

Removal and Installation REMOVAL Remove the front pillar finisher. Refer to INT-24, "Removal and Installation". Remove the front tweeter speaker grille. Refer to IP-10, "E ...

Front door speaker

Removal and Installation REMOVAL Remove the front door finisher. Refer to INT-18, "Removal and Installation". Remove the front door speaker screws (A). Disconnect the harness ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver ...

Blower motor control system
System Diagram System Description Fan speed is automatically controlled by the temperature setting, ambient temperature, in-vehicle temperature, intake temperature, amount of sunload and air mix door position. By pressing the AUTO switch, the blower motor starts to gradually increase a ...

B2608 starter relay
Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: If DTC B2608 is displ ...