Nissan Maxima Owners Manual: Flat tire

Emergency engine shut off

To shut off the engine in an emergency situation while driving, perform the following procedure: Rapidly push the push-button ignition switch three consecutive times in less than 1.5 seconds, ...

Tire Pressure Monitoring System (TPMS)

This vehicle is equipped with the TPMS. It monitors tire pressure of all tires except the spare. When the low tire pressure warning light is lit and the "Tire Pressure Low-Add Air" warning appear ...

Other materials:

Condenser
Removal and Installation REMOVAL Remove the rear pillar finisher LH. Refer to INT-24, "Removal and Installation". Disconnect the harness connector, remove bolt (A), and then remove condenser (1) from the vehicle body. INSTALLATION Installation is in the reverse order of ...

Front passenger air bag module
Removal and Installation CAUTION: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes. Do not use air tools or electric tools for servicing. Always work from the side of air bag module. Do not work from the front of it. Always pl ...

B1081 - B1084 seat belt pre-tensioner RH
Description DTC B1081 - B1084 SEAT BELT PRE-TENSIONER RH The seat belt pre-tensioner RH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unitwill monitor for opens and shorts in detected lines to the seat belt pre-tensioner RH. PART LOCATION DTC Logic DTC DETECTIO ...