To shut off the engine in an emergency situation while driving, perform the following procedure:
Hazard warning flasher switch
Flat tireP2138 APP sensor
Description
The accelerator pedal position sensor is installed on the upper end
of the accelerator pedal assembly. The sensor detects the accelerator
position and sends a signal to the ECM.
Accelerator pedal position sensor has two sensors. These sensors
are a kind of potentiometer which t ...
L terminal circuit (short)
Description
The terminal "L" circuit controls the charge warning lamp. The charge warning
lamp turns ON when the ignition
switch is set to ON or START. When the generator is providing sufficient voltage
with the engine running,
the charge warning lamp turns off. If the charge warning lamp i ...
B2557 vehicle speed
Description
BCM receives the 2 vehicle speed signals via CAN
communication. One signal is transmitted by the "combination
meter". Another signal is transmitted by "ABS actuator and electric unit
(control unit)". BCM compares
both signals to detect the vehicle speed.
DTC Logic
DTC DETECTIO ...