Nissan Maxima Service and Repair Manual: Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.

Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

  • To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
  • Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
  • Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

  • When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
  • When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery, and wait at least 3 minutes before performing any service.
    Accelerator control system
    ...

    Removal and installation
    ...

    Other materials:

    Seat belt buckle switch signal circuit
    Description Transmits a seat belt buckle switch LH signal to the combination meter. Component Function Check 1. CHECK COMBINATION METER INPUT SIGNAL Start engine. Monitor seat belt warning lamp while fastening and unfastening the driver seat belt. Diagnosis Procedure Regarding Wiring ...

    Stall test
    Inspection and Judgment INSPECTION  Inspect the amount of engine oil. Replenish the engine oil if necessary.  Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80C (122 to 176F). Inspect the amount of CVT fluid. Repleni ...

    Intelligent key warning buzzer
    Description Answers back and warns for an inappropriate operation. Component Function Check 1. CHECK FUNCTION With CONSULT Check Intelligent Key warning buzzer OUTSIDE BUZZER in Active Test mode. Diagnosis Procedure 1. CHECK INTELLIGENT KEY WARNING BUZZER Check voltage between BCM connecto ...

    Nissan Maxima Owners Manual

    Nissan Maxima Service and Repair Manual

    © 2017-2024 Copyright www.nimainfo.com
    0.0056