Using the Bluetooth Hands-Free Phone System, a received phone call can be operated on the vehicle information display as well as on the touch-screen display.
1. When there is an incoming call, the caller information and the operation keys are displayed on the vehicle information display.
2. Use
or
to highlight the preferred
item and press the OK button to select
the item.
|
Available keys |
Action |
| [Answer] | Answers the received phone call. |
| [Decline] | Declines the received phone call. |
INFO:
A cellular phone device must be connected and selected among other connected Bluetooth devices before hands-free operation. For additional information, refer to the separate Navigation Owner's Manual.
Audio
Text MessagingPower supply and ground circuit
BCM
BCM : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-67,
"Wiring Diagram".
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuses or fusible link are
blown.
2. CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect B ...
B2604 transmission range switch
Description
BCM confirms the shift position with the following 4
signals.
CVT selector lever
Transmission range switch
P position signal from IPDM E/R (CAN)
P position signal from TCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
I ...
Environmental factors influence the rate of corrosion
Moisture
Accumulation of sand, dirt and water on the vehicle
body underside can accelerate corrosion.
Wet floor coverings will not dry completely inside
the vehicle and should be removed for drying to
avoid floor panel corrosion.
Relative humidity
Corrosion will be accelerated in areas of h ...