Using the Bluetooth Hands-Free Phone System, a received text message can be operated on the vehicle information display as well as on the touch-screen display.
To read/ignore an incoming text
1. When a new text message is received, a pop-up window and operation keys will appear with the sender's name or phone number on the vehicle information display.
2. Use
or
to highlight the preferred
item and press OK to select the item.
| Available keys | Action |
| [Read] | View or hear the received message. |
| [Ignore] | Ignore the received message. |
To reply to/exit from a text
1. When a new text message is received and [Read] is selected, operation keys are displayed on the vehicle information display.
2. Use
or
to highlight the preferred
item and push the OK button to select
the item.
| Available keys | Action |
| [Reply] | Available pre-determined messages will be displayed on the vehicle information display if the steering switch controls are used. Further operations, such as voice recognition reply operation, is available when using the touch-screen display. |
| [Exit] | Ends text message operation and the vehicle information display will show the previous screen. |
INFO
A cellular phone device must be connected and selected from among other connected Bluetooth devices before hands-free operation. For additional information, refer to the separate Navigation Owner's Manual.
Receiving a call
Navigation SystemB terminal C
Description
The "B" terminal is constantly supplied with battery power.
Diagnosis Procedure
CAUTION: Perform diagnosis under the condition that
the engine cannot start by the following procedure.
Remove fuel pump fuse.
Crank or start the engine (where possible) unt ...
RGB synchronizing signal circuit
Description
Transmit the RGB synchronizing signal to the display unit so as to
synchronize the RGB image displayed with
AV control unit.
Diagnosis Procedure
1.CHECK CONTINUITY RGB SYNCHRONIZING SIGNAL CIRCUIT
Turn ignition switch OFF.
Disconnect display unit connector M141 and AV co ...
Programming trouble-diagnosis
If the HomeLink does not quickly learn the
hand-held transmitter information:
replace the hand-held transmitter batteries
with new batteries.
position the hand-held transmitter with its
battery area facing away from the
HomeLink surface.
press and hold both the HomeLink and
hand-hel ...