Service data and specifications (SDS)
PrecautionCondenser
Removal and Installation
REMOVAL
Remove the rear pillar finisher LH. Refer to INT-24, "Removal and
Installation".
Disconnect the harness connector, remove bolt (A), and then
remove condenser (1) from the vehicle body.
INSTALLATION
Installation is in the reverse order of ...
B2560 starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits
the starter relay operation when in N or P position. It is
installed in parallel with the starter relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B2560 is displayed with DTC
U1000, first perform the trouble diagno ...
Center speaker
Removal and Installation
REMOVAL
Remove the center speaker grille, using a suitable tool.
Remove the center speaker screws (A).
Pull out the center speaker (1), disconnect the harness connector
from the center speaker and remove.
INSTALLATION
Installation is in the reverse order of ...