Nissan Maxima Owners Manual: E-call (SOS) switch (if so equipped)

Vehicle Dynamic Control (VDC) off switch

The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The en ...

Power outlet

Console Box The power outlet is for powering electrical accessories such as cellular telephones. It is rated at 12 volt, 120W (10A) maximum. The power outlet is powered only when the ignition ...

Other materials:

System maintenance
The sensor A is located behind the lower grille of the front bumper. To keep the system operating properly, be sure to observe the following: Always keep the sensor area of the front bumper clean. Do not strike or damage the areas around the sensor. Do not cover or attach st ...

Glove box assembly
Removal and Installation REMOVAL Using a suitable tool, gently remove the instrument panel side finisher (RH). Open the glove box door and then remove the glove box assembly screws (A). Remove the glove box assembly lower screws (A). Disconnect the harness connectors, then rem ...

The oil pressure warning lamp does not turn on
Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform IPDM E/R auto active test. Refer to PCS-11, "Diagnosis Description". 2.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT Check the oil pressure sw ...