SERVICE DATA AND SPECIFICATIONS (SDS)
Compressor
Oil

Refrigerant

Heater & cooling unit assemblyIntake sensor
Removal and Installation
REMOVAL
Remove the evaporator (2). Refer to HA-48, "EVAPORATOR:
Removal and Installation".
Release the intake sensor clip (A), then remove the intake sensor
(1).
CAUTION:
Mark the mounting position of the intake sensor.
Do not damage the evapo ...
Rear window glass
Exploded View
Rear window glass
Spacer
Rubber dam (if equipped)
Primer
Rear window molding
Adhesive
16 +2, -0 mm (0.63 +0.08, - 0 in)
7+ 2, - 0 mm (0.28 + 0.08, - 0 in)
12+ 2, - 0 mm (0.47 + 0.08, - 0 in)
Removal and Installation
REMOVAL
Partiall ...
Refrigeration system
Inspection
1.CHECK BLOWER MOTOR OPERATION
Check blower motor operation
2.CHECK COMPRESSOR OPERATION
Check compressor operatio
3.CHECK REFRIGERANT CYCLE PRESSURE
Connect recovery/recycling recharging equipment to the vehicle and perform
the diagnosis with the gauge pressure. Refer to HA ...